Delta RPI-H3 Service Manual download pdf (Page 35)

7.2.3 Connecting the Communication Wiring

Multiple inverters could be monitored via RS-485 connection (Figure 5-6), but

each inverter’s ID must be set.

NOTE:

Make sure the inverter ID is different from each other in the same train.

Single inverter could be monitored RS-485 connection.

7.2.4 Inverter ID Setting

1. Turn on DC power and wait for the LCD display to be ok, then press

“Select” button until “Inverter ID: XX" is shown in the LCD.

2. Press and hold both buttons (“Enter” first then “Select”) until entering

setting ID screen, then you could release the both buttons and set ID by

pressing “Select” button, press “Enter” button if the ID is correct (ID = 1 ~ 254).

3. Inverter ID is changed and saved.

Figure 7-4 Inverter ID Setting

7.3 LCD flowchart

Press any button will enter menu page (Figure 7-5), Today Output Energy is

home page, and several item is described in section 7.3.1 ~ 7.3.6.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 55 56

No comments

Delta RPI-H3 Service Manual Page 35