Delta SoLiViA 3.3 Installation Manual download pdf (Page 22)

22 Operation and installation manual SOLIVIA 3.3 AP G3 TR

NOTE

Please note, that once the country has been selected and conrmed,

it is only possible to change the country by following the steps as listed

below:

1. Please click ESC + for few seconds to get the key information.

2. Provide the key code to the Solar Support Team at

support.australia@solar-inverter.com or support.india@solar-

inverter.com to get the PIN code (valid for one use only!).

3. Once you get the PIN code, you need to press ESC + .

4. Then, you will be asked to insert the PIN code and to conrm it

twice.

5. After conrmation, you will then be able to select the desired

country.

NOTE

These steps must be executed without interruption. Otherwise, you will

stay in the country selection mode.

7.11 LED operation and fault display

Three light-emitting diodes (LEDs), which display the operational state of the solar

inverter, are attached on the front:

Operation (A)

Earth Fault (B)

Failure (C)

● LED (A), green: „Operation“ displays the

operational state.

● LED (B), red: „Earth Fault“ displays an

insulation resistance fault or PV grounding

(GND) fault on the DC side.

● LED (C), yellow: „Failure“ displays existing

faults internally or externally and whether

the grid feed-in operation has been inter-

rupted.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

No comments

Delta SoLiViA 3.3 Installation Manual Page 22