Delta 70-200 Instruction Manual download pdf (Page 10)

Fig. 16

Fig. 17

Fig. 18

MOUNTING THE MACHINE

1. If your drill press is to be used in one permanent

location, the drill press base must be secured to the

supporting surface with fasteners through the four

mounting holes, (A) Fig. 16, in the drill press base.

IF YOU DO NOT FASTEN YOUR DRILL

PRESS IN A PERMANENT MANNER,

THE DRILL PRESS MUST BE FASTENED TO A

PLYWOOD MOUNTING BOARD TO PREVENT THE

DRILL PRESS FROM TIPPING OVER DURING

NORMAL USE.

USE A GOOD GRADE OF PLYWOOD

WITH A MINIMUM 3/4

″″

THICKNESS.

DO NOT MAKE THE MOUNTING BOARD FROM

PARTICLE BOARD SINCE PARTICLE BOARD CAN

BREAK EASILY.

2. Use a playwood board base with the minimum

dimensions shown in Fig. 17 for mounting the drill press

to a supporting surface.

3. Place the drill base, as shown in Fig. 18, centered on

the supporting surface.

WHEN THE DRILL PRESS IS

MOUNTED TO THE SUPPORTING

BOARD, THE BOARD MUST EXTEND A MINIMUM

OF 3

″″

BEYOND EACH EDGE OF THE DRILL PRESS

BASE, AS SHOWN IN FIG. 18.

4. Drill four 3/8″ diameter holes (B) Fig. 17, corresponding to

the mounting holes (A) Fig. 16, of the drill press base in a 26″

x 32″ minimum size plywood board.

PLACE A PIECE OF SCRAP WOOD

UNDERNEATH THE SUPPORTING

SURFACE WHEN DRILLING THE THROUGH HOLES

SO THAT THE DRILL BIT WILL NOT DAMAGE THE

MATERIAL BENEATH THE SUPPORTING SURFACE.

5. Fasten the drill press base to the mounting board

using the carriage bolts, nuts, and washers (C) Fig.17,

furnished with your drill press. For stability, the holes for

the carriage bolt heads and flat washers must be

countersunk so the bolt heads are flush with the bottom

surface of the mounting board.

″″

Minimum

″″

Minimum

″″

Minimum

″″

Minimum

ASSEMBLY

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE

MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

ASSEMBLY TOOLS REQUIRED

* 3mm, 4mm and 5mm hex wrenches (supplied) * 13mm, 17mm and 29mm socket wrenches (not supplied)

* Soft tip hammer (not supplied)

ASSEMBLY TIME ESTIMATE 1-2 hours.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Comments to this Manuals

No comments

Delta 70-200 Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Power drills Delta 70-200