Delta 70-200 Instruction Manual download pdf (Page 13)

8. Reassemble collar (D) Fig. 7, which was removed in

STEP 1, to column. IMPORTANT: Bottom of collar (D)

MUST NOT be pushed all the way down onto top of raising

rack (E). MAKE SURE top of raising rack (E) is under

bottom of collar (D) and that there is enough clearance to

allow rack (E) to rotate around the column. Then tighten set

screw (Q) being careful not to overtighten.

10. Assemble table raising and lowering handle (N) Fig.

10, to shaft on table bracket. Line up flat on shaft with

screw (O) and tighten screw (O).

Fig. 10

Fig. 7

Fig. 8

Fig. 9

9. Assemble table (G) Fig. 8, to table bracket (H) using

bolt (F). Line up hole (S) in table with hole in table bracket

and insert pin (P) Fig. 9.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20 21

No comments

Delta 70-200 Instruction Manual Page 13