Delta DP350 Instruction Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
11
ADJUSTING THE TABLE
3. You can tilt the table right or left by removing the
table alignment pin (C) Fig. 21.
NOTE: If the pin (C) is difficult to remove, turn the nut (E)
clockwise to pull the pin out of the casting.
4. The table alignment pin (C) is removed in Fig. 22.
Loosen the table locking bolt (D), tilt table to the
desired angle and tighten bolt (D). When you return
the table to the level position, replace the alignment
pin (C) to position the table surface 90 degrees to
the spindle.
5. A tilt scale (E) Fig. 23 on the table bracket casting
indicates the degree of tilt. A witness line and zero
mark (F) are also provided on the table.
Fig. 19
Fig. 20
Fig. 21
Fig. 22
Fig. 23
1. You can raise or lower the table by loosening the table clamp (A) Fig. 19, and turning the table adjusting handle (B)
Fig. 20. After the table is at the desired height, tighten clamp (A) Fig. 19.
NOTE: To get your final positioning, go a little lower than your desired height, come back to that height, and lock it in.
2. You can rotate the table 360 degrees on the column by loosening the clamp (A) Fig. 19, rotating the table to the
desired position, and tightening the clamp (A).
A
B
D
C
E
D
C
F
E
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Comments to this Manuals

No comments