Delta N081935 Instruction Manual download pdf (Page 14)

TABLE ADJUSTMENTS

To reduce the risk of injury, turn unit off

and disconnect it from power source before installing

and removing accessories, before adjusting or when

making repairs. An accidental start-up can cause injury.

RISK OF PERSONAL INJURY. Make sure

that nothing is on the table and that the workpiece is

clamped down. Falling objects can cause an injury.

Tilting table back to front

from zero (0) to 45 degrees

To adjust:

1. Loosen the two forward tilt knobs (OO) Fig. 27.

2. Adjust the table to your desired angle. The scale

(PP) Fig. 27 is located on the side of the table

support.

3. Tighten the knobs (OO) Fig. 27.

4. A positive stop screw (QQ) Fig. 28 is provided to

return the table to the zero position. Adjust this

stop by turning the hex head of the stop screw (RR)

Fig. 29 from under the table. Tighten the locknut (SS)

Fig. 29 to secure the stop.

Tilting table right to left

from zero (0) to 90 degrees

An index pin is included for the 0 degree position of the

table. To adjust:

1. Loosen the table bolt (TT) Fig. 29 approximately

1/4 turn with the supplied table locking wrench

(Fig. 29).

2. Pull out the index pin (UU) Fig. 30 (inset).

3. Rotate the table to your desired angle. The tilt scale

(VV) Fig. 30 is located on the knuckle behind the

table. Use this scale for accuracy.

4. Tighten the table bolt (TT) Fig. 29.

5. When you return the table to zero, re-insert the index

pin (UU) Fig. 30 (inset).

Fig. 30

Fig. 28

Fig. 27

Fig. 29

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

No comments

Delta N081935 Instruction Manual Page 14