Delta 18657 Instruction Manual download pdf (Page 10)

10 - English

FASTENING PLANER TO SUPPORTING SURFACE

During operation, if there is any tendency

Fig. 9

for the planer to tip over, slide or “walk” across the

supporting surface, the planer must be secured to the

supporting surface. Four holes (two of which are at (A)

Fig. 9) are provided for this purpose.

Operate the planer on a flat, level surface.

If you attach the planer to one of the accessory stands

(models 50-326 or 50-322), align the four holes in the

base of the machine, two of which are shown at (A) Fig.

9, with the four holes in the top of the stand. Place the

carriage head flange bolt through the holes in the planer

and the stand. Thread the flange nut on the carriage head

flange bolt. Tighten it securely.

OPERATION

OPERATIONAL CONTROLS AND ADJUSTMENTS

STARTING AND STOPPING THE PLANER

The on/off switch Fig. 10 is located on the front of the

Fig. 10

planer motor. To turn the machine “ON”, move the

switch (A) up to the "ON" position. To turn the machine

“OFF”, push down on the switch shield (B) Fig. 10.

LOCKING THE SWITCH IN THE “OFF” POSITION

IMPORTANT: When the machine is not in use, the

Fig. 11

switch should be locked in the “OFF” position to prevent

unauthorized use. Raise the infeed table to the upright

position. Place a padlock with a 3/16" (4.7 mm) diameter

shackle through the hole in the left side of the planer

and through the infeed table (Fig. 11). Lock the padlock.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 53 54

No comments

Delta 18657 Instruction Manual Page 10