Delta 18657 Instruction Manual download pdf (Page 9)

9 - English

LOWERING THE EXTENSION TABLES

The infeed and outfeed table extensions (A) Fig. 3 are

Fig. 3

shipped in the “UP” position on the machine. Lower both

table extensions (A) to the "DOWN" position (Fig. 3). To

check and adjust the top surface of the table extensions

(A) level with the planer table, refer to the section of this

manual entitled “LEVELING TABLE EXTENSIONS.”

CUTTERHEAD LOCK HANDLE

Use the supplied wrench to attach the cutterhead lock handle (A) Figs. 4 & 5, to the shaft (B) with the M6-20mm hex

socket-head screw (C) Fig. 5.

Fig. 4

Fig. 5

CUTTERHEAD ADJUSTMENT HANDLE

1. Attach the cutterhead adjustment handle (A) Fig. 6 to the shaft (B), making certain that the flat on the shaft is

engaged with the flat in the handle.

2. Fasten the cutterhead adjustment handle (A) Fig. 7 to the shaft using the M5-16 mm hex socket-head screw (C)

with the hex end of the supplied cutterhead wrench.

3. Rotate handle (A) to the operating position as shown in Fig. 8.

Fig. 6

Fig. 7

Fig. 8

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 53 54

No comments

Delta 18657 Instruction Manual Page 9