Delta 22-790X Instruction Manual download pdf (Page 18)

1. Make certain the knives are adjusted properly as explained under How To Check, Adjust, And Re place Knives.

 



gauge. Lock the head assembly.

 





top of the gauge block.

4. To adjust the height of the chipbreaker, remove

         

          

chipbreaker is properly adjusted. Tighten the nut



5. Place the gauge block on the other end of the





HOW TO ADJUST THE HEIGHT OF THE CHIPBREAKER

The chipbreaker extends down around the front of the cutterhead and raises as the stock is fed through the planer.

The chipbreaker “breaks" or "curls” the chips as they leave the cutterhead. The bottom edge of the chipbreaker helps

hold the stock flat on the table. To confirm that the bottom of the chipbreaker is parallel to the knives and set 0.020"



Fig. 48

Fig. 49 Fig. 50

Disconnect the machine from the power source.

HOW TO ADJUST THE HEIGHT OF THE INFEED ROLLER



of the infeed roller:

Disconnect the machine from the power source.

1. Confirm that the knives are adjusted properly as

ex plained under How To Check, Adjust, And

Re place Knives.

 





Raise or lower the head assembly until one of the

knives touches the feeler gauge. Tighten the head-

locking knobs.

Fig. 51

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 71 72

No comments

Delta 22-790X Instruction Manual Page 18