Delta 37-380 Instruction Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
15
2. Raise or lower the infeed table adjustment lever (C)
Fig. 35.
3. IMPORTANT: When lowering the infeed table, a
depth stop (D) Fig. 35, will automatically stop the table
at a 1/8" depth-of-cut. To move the table past this point,
the depth stop (D) Fig. 36, must be raised, while
simultaneously lowering the infeed table. Always make
certain table locking handles (A) Fig. 34, and (B) Fig. 35,
are tight before operating the jointer. The locking
handles are spring-loaded and can be repositioned by
pulling outward on the handle and repositioning it on the
serrated nut located underneath the handle.
4. The depth-of-cut of the infeed table (position of the
infeed table in relation to the cutting circle) is indicated
on scale (E) Fig. 36. NOTE: Maximum depth-of-cut with
this jointer is 1/2", which can be accomplished in cuts of
1/8" increments.
Fig. 35
Fig. 36
B
D
E
B
D
INFEED TABLE
POSITIVE STOPS
DISCONNECT MACHINE FROM
POWER SOURCE.
Positive stops are provided to limit the height and depth
of the infeed table. To adjust the stops, loosen two
locknuts (F) and (G) Fig. 37, and turn the two adjusting
screws (J) and (K) as required. Then retighten the
locknuts (F) and (G). A good suggestion is to set the
upper positive stop (J) for your finish or final cut. This
means that you will be able to rapidly set the infeed table
for a finish or final cut without checking the scale and
pointer. Also the lower positive stop (K) can be set for
the maximum depth-of-cut or if you desire to limit the
depth-of-cut, adjust the stop screw (K) accordingly.
Fig. 37
K
F
G
J
OUTFEED TABLE
ADJUSTMENTS
DISCONNECT MACHINE FROM
POWER SOURCE.
1. In order to perform accurate jointing operations, the
outfeed table must be exactly level with the knives at
their highest point of revolution. This means that the
knives must be parallel to the outfeed table and project
equally from the cutterhead.
2. To move the outfeed table up or down, loosen lock-
screw (A) Fig. 38, and turn hand knob (B). When the
outfeed table is exactly level with the knives at their
highest point of revolution, tighten lockscrew (A).
Fig. 38
A
B
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Comments to this Manuals

No comments