Delta 37-380 Instruction Manual download pdf (Page 19)

4. Rotate flip stop (F) Fig. 54, and tilt the fence outward

as far as it will go and tighten locking handle (D). Place

a square (K) on the table and against the fence to check

if the fence is 45 degrees outward to the table.

5. If an adjustment to the positive stop is necessary,

loosen locking handle (D) Fig. 54, and locknut (M). Rotate

adjustment screw (N) until you are certain the fence is 45

degrees outward to the table. Tighten locknut (M).

6. Tilt the fence (G) Fig. 55, inward as far as it will go

and tighten locking handle (D). Using a square (K) on the

table and against the fence, check if the fence is 45

degrees inward to the table.

7. If an adjustment is necessary, loosen locknut (P)

Fig. 55. Rotate screw (R) until you are certain the fence

is 45 degrees inward to the table. Tighten locknut (P)

and locking handle (D).

Fig. 54

Fig. 55

REMOVING, REPLACING,

AND RESETTING KNIVES

If the knives are removed from the cutterhead for re-

placement or sharpening, care must be used in

removing, replacing, and resetting them.

DISCONNECT MACHINE FROM

POWER SOURCE.

1. Move the fence to the rear and remove the

cutterhead guard.

BE EXTREMELY CAREFUL THAT

YOUR HANDS DO NOT COME IN CONTACT WITH

THE KNIVES. THE KNIVES ARE VERY SHARP.

2. Using wrench (A) Fig. 56, slightly loosen the four

locking screws (B) in each knife slot by turning the

screws (B) clockwise.

3. Loosen screws (B) Fig. 56, further and remove knife

and knife locking bar.

4. Fig. 57, shows the knife (C) and knife locking bar (D)

removed from the cutterhead. Remove the remaining

two knives and locking bars, in the same manner.

5. Using wrench (E) Fig. 57, lower the two knife

adjustment blocks by turning screws (F) counterclockwise

in all three slots of the cutterhead.

6. Before replacing knives make certain the knife

locking bars are thoroughly clean and free of gum and

pitch.

7. Replace the knife locking bars (D) Fig. 57, and knives

CARE MUST BE TAKEN WHEN

INSERTING THE KNIVES AS THE CUTTING EDGES

ARE VERY SHARP. Push the knife down as far as

possible and snug up the screws (B) Fig. 56, by turning

each screw counterclockwise just enough to hold the

knife in position. Replace the remaining two knifes in the

same manner.

Fig. 56

Fig. 57

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Comments to this Manuals

No comments

Delta 37-380 Instruction Manual Page 19

Comments to this Manuals

Related products and manuals for Power planers Delta 37-380