Delta 37-380 Instruction Manual download pdf (Page 9)

2. Remove the four bolts that attach the motor (A) Fig.

5 to top of the stand. NOTE: SAVE THESE BOLTS AS

THEY WILL BE USED TO ATTACH THE MOTOR TO

THE MOUNTING BRACKETS.

Fig. 5

5. Line up three holes (F) and (L) Fig. 6, on top of stand

with three holes located at the bottom of the jointer

base. Place a 3/8" flat washer (H) Fig. 7, on a 3/8-16x2"

hex head screw (G), insert the screw through the hole in

the base of the Jointer and hole (F) Fig. 6, in the stand.

Place a 3/8" flat washer (H) Fig. 7, 3/8" lockwasher (J),

and thread a 3/8-16 hex nut (K) onto the screw and

tighten securely. Repeat this process for the remaining

hole (F) in the stand and Jointer base. Repeat this

process for hole (L) in the stand and Jointer base by

inserting the screw up through hole (L) in the stand and

the Jointer base.

Fig. 6

THE JOINTER IS EXTREMELY HEAVY.

HAVE TWO OR MORE PEOPLE LIFT THE MACHINE

ONTO THE STAND OR LIFT THE JOINTER

MECHANICALLY.

Fig. 7

Fig. 8

ASSEMBLING INFEED TABLE

ADJUSTMENT HANDLE

1. Thread an M14x2 hex nut (A) Fig. 8, clockwise onto

the end of adjustment handle (B) as far as it will go.

2. Thread handle (B) Fig. 8, into block (C) which is

located under infeed table (D). Tighten hex nut (A) Fig. 8,

against block (C).

3. Align the holes in the motor mounting plate (B) Fig.

5A with the four holes in the two motor mounting

brackets (C). Attach the motor to the motor mounting

brackets with the hardware that was removed in STEP 2.

NOTE: MAKE SURE THAT MOTOR SHAFT (D) FIG 5A

IS FACING OUT OF THE OPENING IN THE MOTOR

CABINET AS SHOWN.

4. Turn the stand over so that it is resting on its base

as shown in Fig. 6.

Fig. 5A

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Delta 37-380 Instruction Manual Page 9