Delta TP400LS Instruction Manual download pdf (Page 10)

FASTENING PLANER TO STAND

2. Fasten cutterhead raising and lowering handle (A)

Fig. 8, to shaft using the M5x.8x20mm hex socket head

screw (C) with wrench supplied.

3. Rotate handle (A) to the operating position as shown

in Fig. 9, and tighten set screw (D).

Place the planer on the stand and align the four holes in

the base of the machine, two of which are shown at (A)

Fig. 10, with the four holes in the top of the stand. Place

the M8x1.25x35mm hex head flange bolt through the

holes in the planer and the stand, and thread the

M8x1.25 flange nut onto the hex head flange bolt and

tighten securely. Only operate planer, attached to stand,

on a flat level surface.

Fig. 8

Fig. 9

Fig. 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

No comments

Delta TP400LS Instruction Manual Page 10