Delta TP400LS Instruction Manual download pdf (Page 17)

Fig. 34

Fig. 35

2. Make sure the knives are inserted into the cutterhead

properly, as explained under “REPLACING KNIVES.”

3. Place the gage block (A) Fig. 34, on the table, over a

0.020" feeler gage and position the gage block (A) directly

underneath the cutterhead. Raise or lower the head

assembly and rotate the cutterhead, by following STEP

5 under “REPLACING KNIVES,” until one of the knives

(B) just touches the top of the gage block when the knife

is at its lowest point. Then tighten cutterhead lock

handle.

4. Move the gage block (A) Fig. 35, minus the feeler

gage, under one end of the outfeed roller (C) as shown.

The bottom of the outfeed roller should just touch the

top of the gage block.

5. If the height of the outfeed roller must be adjusted,

loosen locknut (D) Fig. 35, and turn adjusting screw (E)

until outfeed roller just touches the gage block (A).

Tighten locknut after adjustment is made.

6. Repeat this adjustment on opposite end of outfeed

roller (C) Fig. 35.

When using your machine, you may want to follow these few simple steps for achieving the best results possible.

1. T

rue Up One Face – Feed one face of the board over a jointer, making thin cuts with each pass, until the entire

surface is flat.

2. Plane to Thickness – Place the side you just surfaced in STEP 1 face down and feed the board through the planer,

plane until this side is flat. Then plane both sides of the board until you are satisfied with the thickness, making thin

cuts, alternating sides with each pass. If during the planing operation you notice the board twisting, warping or bowing,

repeat STEP 1 and true up one face.

3. When planing long stock, provide table extensions to support the infeed and outfeed end of the workpiece.

4. For best results, always engage cutterhead lock before planing, plane with the grain only, and keep planer table clean.

Occasionally, wax table surface to reduce friction during the planing operation.

5. Cr

oss-cut to Final Length – Cross-cut lumber to final length, to remove any snipe which may have occurred during

the planing operation.

NOTE: THE KNIVES ON THE PLANER WILL NOT WEAR EVENLY IF THE WOOD IS FED THROUGH THE SAME

SPOT ON THE TABLE EVERY TIME. FEED THE WOOD THROUGH THE PLANER AT DIFFERENT SPOTS ON THE

TABLE WHEN POSSIBLE, TO HELP ELIMINATE UNEVEN WEAR OF THE KNIVES.

OPERATION

1 2 ... 12 13 14 15 16 17 18 19 20 21

No comments

Delta TP400LS Instruction Manual Page 17