Delta TP400LS Instruction Manual download pdf (Page 9)

Fig. 4

Fig. 5

Fig. 6

LOWERING

EXTENSION TABLES

The infeed and outfeed table extensions (A) Fig. 4, are

shipped attached to the machine in the “UP” position.

Rotate both table extensions to the down position as

shown. The top surface of the table extensions should

be level with the planer table. To check and adjust if

necessary, refer to the section of this manual entitled

“LEVELING TABLE EXTENSIONS.”

CUTTERHEAD

LOCK HANDLE

1. Assemble the cutterhead lock handle (A) Fig. 5, to

shaft (B).

2. Fasten cutterhead lock handle (A) Fig. 6, to the shaft

using the M6x20mm special hex socket head screw (C),

with wrench supplied.

CUTTERHEAD RAISING AND

LOWERING HANDLE

1. Assemble the cutterhead raising and lowering handle

(A) Fig. 7, to shaft (B), making certain flat on shaft is

engaged with flat in handle.

Fig. 7

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

No comments

Delta TP400LS Instruction Manual Page 9