Delta 20-950 Instruction Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 52
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
11
Hold the chuck on the taper of the spindle. Tap it with a
soft-tip hammer (Q) Fig. 19 or a block of wood and hammer
to set the chuck.
Thread the three pinion shaft handles (R) in the three holes
located in the pinion shaft hub (S) Fig. 20.
Fig. 20
Fig. 19
Q
S
R
RISK OF PROPERTY DAMAGE. To
avoid damage to the chuck, NEVER drive the chuck on the
spindle with a metal hammer.
ATTACHING THE PINION SHAFT HANDLES
1. Align the two holes in the lamp bracket (A) Fig. 21, with the two holes (B) on the side of the drill press head.
2. Place the cord bushing (Inset) Fig. 21, around the top of the lamp cord (D)
3. Align the two holes in the lamp cord bracket with the two holes in the lamp bracket and drill press head.
4. Place a 1/4" washer on an M6x1x12mm cap head screw. Insert the screw through the hole in the cord strain relief bracket
and the lamp bracket. Thread the screw into the drill press head (Fig. 22). Repeat this process for the remaining hole in
the cord strain relief bracket and tighten both screws securely.
5. Peel the backing from the cord clamps (H) Fig. 23, and
apply the clamps at the locations shown. Make certain
that the lamp cord is routed out of the way of the drill,
then secure the cord (J) to cord clamp (H) Fig. 23.
A
B
H
J
Fig. 21
Fig. 22
Fig. 23
ATACHING THE CORD BRACKET
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Comments to this Manuals

No comments