Delta 20-950 Instruction Manual download pdf (Page 8)

3" MINIMUM

28"

MINIMUM

21" MINIMUM

1. If you plan to use your drill press in a permanent

location, you must secure the drill press base to the

supporting surface with fasteners through the three

mounting holes (A) Fig. 1 in the drill press base.

RISK OF UNSAFE OPERATION. If you

do not fasten your drill press in a permanent manner,

you must fasten the drill press to a plywood mounting

board to prevent the drill press from tipping over

during normal use.

RISK OF UNSAFE OPERATION. Use

a good grade of plywood with a minimum 3/4"

thickness. Do not make the mounting board from

particle board since particle board breaks easily.

2. Use a plywood board base with the minimum

dimensions as shown in Fig. 2 for mounting the drill

press base to a supporting surface.

3. Place the drill press base (D) Fig. 3 centered on the

supporting surface (E).

RISK OF UNSAFE OPERATION. Make

sure that the plywood extends a minimum of 3" on all

four sides of the base as shown in Fig. 5.

4. Drill three 3/8" diameter holes through the holes (A)

Fig. 1 in the drill press base, and in the supporting

surface (E) Fig. 3.

NOTE: Place a piece of scrap wood underneath the

supporting surface when drilling the through holes so

that the drill bit will not damage the material beneath

the supporting surface.

5. Fasten the drill press base to the mounting board

using the carriage bolts, flat washers, lockwashers,

and hex nuts (C) Fig. 2 furnished with your drill

press. Countersink the holes for the carriage bolt

heads and flat washers under the board so that

the bolt heads are flush with or below the bottom

surface of the board. Use a flat washer, lock washer,

and hex nut above the drill press base.

Fig. 1

ASSEMBLY

ASSEMBLY TOOLS REQUIRED

3mm and 5mm hex wrench (supplied)

10mm, 17mm, 24mm open end or socket wrenches (not supplied)

ASSEMBLY TIME ESTIMATE

Assembly for this machine takes approximately 30 minutes to 1 hour.

RISK OF UNSAFE OPERATION. For your own safety, do not connect the machine to the power source

until the machine is completely assembled and you read and understand the entire instruction manual.

Fig. 2

Fig. 3

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 51 52

Comments to this Manuals

No comments

Delta 20-950 Instruction Manual Page 8

Comments to this Manuals

Related products and manuals for Power sanders Delta 20-950