INSTRUCTION MANUAL1" Belt / 5" DiscSander(Model 31-080)PART NO. 901607 (0112)Copyright © 2001 Delta MachineryESPAÑOL: PÁGINA 13To learn more
10Fig. 26Fig. 23Fig. 24Fig. 25CHANGING ABRASIVE BELT1. DISCONNECT MACHINE FROM POWER SOURCE.2. Remove lock knob (A) Fig. 23, and remove sidecover (B).
11Fig. 27Fig. 28MITER GAGEA miter gauge (A) Fig. 27, is supplied with your sanderand can be used on the disc table. The miter gauge head(A) can be set
12Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which
2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha
3ADDITIONAL SAFETY RULES FORBELT / DISC SANDERSWARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.SAVE THESE INSTRUCTIONS. R
4Fig. A Fig. BGROUNDED OUTLET BOXCURRENTCARRYINGPRONGSGROUNDING BLADEIS LONGEST OF THE 3 BLADESGROUNDED OUTLET BOXGROUNDINGMEANSADAPTERPOWER CONNECTIO
Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug a
6ASSEMBLYATTACHING BELT SANDER TABLE1. DISCONNECT MACHINE FROM POWER SOURCE.2. Locate the 1-3/16" long screw (A) Fig. 2, M8.4 flatwasher (B), and
7ATTACHING ABRASIVE TOSANDING DISC1. DISCONNECT MACHINE FROM POWER SOURCE.2. Remove one-half of the abrasive backing (A) Fig. 7,to expose the adhesive
8Fig. 15Fig. 16Fig. 17OPERATING CONTROLS AND ADJUSTMENTSSTARTING ANDSTOPPING SANDERThe switch (A) Fig. 15 is located on the top of the switchbox. To s
9Fig. 22Fig. 21Fig. 20Fig. 19The disc table (C) can be tilted down 45 degrees (Fig.21), by loosening the two wing nuts (one of which isshown at (B) Fi
Comments to this Manuals