INSTRUCTION MANUAL1" Belt / 8" Disc Sander(Model 31-340)PART NO. 902120 (0112)Copyright © 2001 Delta MachineryESPAÑOL: PÁGINA 19To learn mor
10Fig. 17Fig. 18ASSEMBLING BELTSANDER TABLE1. DISCONNECT MACHINE FROM POWER SOURCE.2. Position the table assembly (A) Fig. 17, in position onthe belt
11Fig. 23TRACKING THESANDING BELTThe belt tracking adjustment is set at the factory so thatthe belt (A) Fig. 23, will run true on the pulleys. If,howe
12Fig. 27The table can be tilted 45 degrees to the front, as shownin Fig. 27, by loosening lock lever (B). Using acombination square (E) check to see
13Fig. 31Fig. 32REMOVING ANDINSTALLINGABRASIVE BELTS1. DISCONNECT MACHINE FROM POWER SOURCE.2. Unscrew and remove the two knobs (A) Fig. 31, andremove
14TYPICAL OPERATIONSWARNING: THE USE OF ATTACHMENTS ANDACCESSORIES NOT RECOMMENDED BY DELTAMAY RESULT IN RISK OF INJURIES.The following are just some
15Fig. 39Fig. 40Fig. 41Polishing using the Delta accessory Felt Belt in place ofthe sanding belt. Sanding in tight areas with the sanding belt.Inside
16Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which
17NOTES
18NOTES
2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha
3ADDITIONAL SAFETY RULES FORBELT / DISC SANDERSWARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.SAVE THESE INSTRUCTIONS. R
4POWER CONNECTIONSA separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected
Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cordwhich has a 3-prong grounding type plug a
6ASSEMBLYFig. 1Fig. 2Fig. 3Fig. 4ASSEMBLINGBELT UNIT TO BASE1. Place a 10mm lockwasher (D) Fig. 1, and a 10mm flatwasher (E) onto a M10x20mm hex socke
7Fig. 5Fig. 6Fig. 7Fig. 8ASSEMBLING GUARDFOR SANDING DISCAND BELT AND PULLEYS1. DISCONNECT MACHINE FROM POWER SOURCE2. Position the guard (A) Fig. 5,
8Fig. 9Fig. 10Fig. 11Fig. 12ASSEMBLING SANDING DISCPLATE TO MOTOR SHAFT1. DISCONNECT MACHINE FROM POWER SOURCE.2. Assemble the sanding disc plate (A)
9Fig. 13Fig. 14Fig. 15Fig. 16ASSEMBLING SANDINGDISC TABLE1. DISCONNECT MACHINE FROM POWER SOURCE.2. Two clamp handles are supplied with your machine,o
Comments to this Manuals