Delta 31-481 Operations Instructions download pdf (Page 11)

FIG. 9

TO REPLACE THE FEED BELT

This step requires two adults. The feed table is heavy, be careful when disconnecting and

removing it from the machine. Failure to comply may cause serious injury and/or damage to the

sander and/or property!

ADJUSTMENTS

1. Using the table elevation crank and handle, lower

the table as far as it will go.

2. Release tension on the feed belt by backing off

the locking nuts (A) on the feed belt adjustment

bolts (Fig. 8) and then tightening the feed belt

adjustment bolts (B) until they are loose enough to

remove the feed belt assembly.

3. Loosen but do not remove the eight Philips head

screws (C) holding the bearings to either side of the

front of the feed table. See Fig. 9.

4. Remove the front guard (D) by sliding it forward.

5. Locate and remove the four 6mm hex head screws

(E) securing the feed table to the base. See Fig. 10.

6. With the aid of a second adult, carefully remove the

feed table through the rear of the machine being

careful to angle it away from the motor housing.

7. Position the feed table on its side and remove the

worn feed belt.

8. Carefully slide the new feed belt into place.

9. Slide feed belt assembly back onto machine base

through the rear, being careful not to damage motor

housing.

10. Replace and tighten the four 6mm hex cap head

screws to secure the feed table to the machine

base.

11. Replace the front guard and retighten the Phillips

head screws on each bearing.

12. Re-tension the feed belt.

13. Adjust the tracking as described on page 9.

FIG. 10

FIG. 8

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 49 50

No comments

Delta 31-481 Operations Instructions Page 11