Delta 31-481 Operations Instructions download pdf (Page 8)

FIG. 2

ASSEMBLY

TOOLS REQUIRED

• Flat head screw driver

• 10mm open-end wrench

FIG. 3

SECURE SWITCH BOX TO FRAME

Tools Required: 10mm open-end wrench

Parts: None

Hardware Needed: Two 10mm hex head screws

1. Locate the two threaded holes on the upper right side of

the machine as shown in Fig. 2.

2. Attach the two 10mm hex head screws to the mounting

plate, leaving about 1/8” between the screw head and

mounting plate.

3. Mount switch assembly (A) to the machine frame by

aligning the keyholes (B) in the switch assembly over the

screw heads and pushing the assembly back and into

position.

4. Tighten screws using 10mm open-end wrench.

ASSEMBLE TABLE ELEVATION

CRANK AND HANDLE

Tools Required: None

Parts: Table Elevation Crank

Table Elevation Handle

Hardware Needed: None

1. Install the table elevation crank (C) by aligning the

groove in the bottom of the crank with the pin located on

the shaft (D). See Fig. 3.

2. Screw the table elevation handle into the threaded hole

in the table elevation crank.

CONNECT DUST COLLECTOR TO DUST COLLECTION PORT

Tools Required: Flat head screwdriver

Parts: None

Hardware Needed: Two 4” Ring Clamps (not provided)

Your DELTA

Dual Drum Sander is equipped with two 4-inch dust collection ports. These must be connected to dust

collector hoses to ensure safe operation.

Do not attempt to operate this tool without first connecting it to an adequate dust collection system.

1. Fit a 4” ring clamp over the end of each dust collection hose.

2. Place a dust collection hose over each dust collection port and tighten ring clamp with the flat head screwdriver.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 49 50

No comments

Delta 31-481 Operations Instructions Page 8