Delta 31-482 Operations Instructions download pdf (Page 10)

INSTALLING THE CONTOUR SANDING TABLE

TOOLS REQUIRED

• 12 mm socket wrench

PARTS

• Contour Sanding Table

• Mounting Pole

• Mounting Bracket

• 20mm Lock Knob

HARDWARE NEEDED

• 10-24 x 3/4 Socket Head Cap Screws (2)

• 12mm Hex Cap Bolt

1. Loosen the lock knobs (A) on the drum guard (B)

and rotate the drum guard back and out of the

way. Retighten the lock knobs.

2. Attach the mounting bracket (C) to the side of the

motor housing and secure using the two 10-24 x

3/4 socket head cap screws, as shown in Fig. 7.

The longer end of the mounted bracket should be

at the bottom.

3. Insert the mounting pole (D) into the contour

sanding table (E) and secure with 12mm hex cap

bolt and lock nut.

4. Insert the mounting pole/table assembly into the

mounting bracket. Ensure there is clearance on all

sides between the sanding belt and the contour

sanding table.

5. Secure the mounting pole/table assembly to the

mounting bracket using the (20mm) lock knob (F).

Important: When the contour sanding table is not in

use, the drum guard/dust port should always be in the

closed position so the drive drum is not in view.

FIG. 8

FIG. 7

INSTALLING THE WORKPIECE SUPPORT

TOOLS REQUIRED

• None

PARTS

• Workpiece Support

• (35mm) Lock Knob

HARDWARE NEEDED

• None

1. Locate the two holes (A) on the right hand side of

the top of the sanding platen. See Fig. 8.

2. Insert the pin of the workpiece support (C) into the

hole closest to the front.

3. Secure the workpiece support to the sanding

platen by screwing the (35mm) lock knob (D) into

the tapped hole closest to the rear.

4. Ensure the workpiece support is as close to the

sanding belt (B) as possible without touching it.

5. Tighten the lock knob.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Comments to this Manuals

No comments

Delta 31-482 Operations Instructions Page 10

Comments to this Manuals

Related products and manuals for Power sanders Delta 31-482