Delta 31-482 Operations Instructions download pdf (Page 8)

FIG. 2

CABINET ASSEMBLY

TOOLS REQUIRED

• 12mm wrench

• Phillips head screw driver

PARTS

• Rubber Feet (4)

• Side Cabinet Panels (2)

• Front Cabinet Panel with

Door (1)

• Rear Cabinet Panel (1)

• Cabinet Shelf (1))

HARDWARE NEEDED

• 5/16” x 5/8” screws (4)

• 5/16” flat washers (20)

• 5/16” hex nuts (12)

• 5/16” x 5/8” hex cap bolts (8)

• 5/16” lock washers (8)

• M5x10 pan head screws (2)

• M5 flat washers (2)

• M5 lock washers (2)

Before beginning assembly, clean all rust protected

surfaces with a mild solvent. Do not use paint or lacquer

thinner, gasoline, or mineral spirits; as these will damage

painted surfaces.

NOTE: To ensure the top cabinet surface, where you will

mount the tool, is level and flush, assemble the cabinet

upside down on a flat surface.

1. Referring to Fig. 2, attach the four rubber pads (A) to

the bottoms of the side panels (B) with four each 5/16”

x 5/8” screws, 5/16” flat washers and 5/16” hex nuts.

2. Use four 5/16” x 5/8” hex cap screws, eight 5/16” flat

washers, four 5/16” lock washers, and four 5/16” hex

nuts to attach the side panels (B) to the front panel (C).

Hand tighten only.

3. Attach the rear cabinet panel (D) to the side panels

using four 5/16” x 5/8” hex cap screws, eight 5/16” flat

washers, four 5/16” lock washers, and four 5/16” hex

nuts.

4. Turn cabinet right side up on a level surface and ensure

the top edges of all panels are flush.

5. Install the cabinet shelf (E) to the inside of the cabinet

using two M5x10 pan head screws, two M5 flat

washers and two M5 lock washers.

6. Tighten all hardware.

MOUNTING THE TABLE ASSEMBLY TO THE CABINET

TOOLS REQUIRED

• 12 mm wrench

PARTS

• Table Assembly

HARDWARE NEEDED

• 5/16” x 1-1/4” hex cap screws (2)

• 5/16” lock washers (2) 5/16” flat washers (2)

This step requires two adults. The table

assembly is heavy, be careful when

lifting it onto the stand! Failure to comply may cause

serious injury and/or damage to the sander and/or

property!

1. With the aid of another person, carefully lift the table

assembly onto the cabinet and position it so that the

two holes in the base of the table assembly align with

the holes located on either end of the cabinet. See

Fig. 3.

2. Open the cabinet door and, from inside the cabinet,

feed a 5/16” x 1-1/4” hex cap screw up through both

holes and secure using a 5/16” lock washer and 5/16”

flat washer. See Fig. 5.

3. Tighten hardware using a 12mm socket wrench.

FIG.3

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Comments to this Manuals

No comments

Delta 31-482 Operations Instructions Page 8

Comments to this Manuals

Related products and manuals for Power sanders Delta 31-482