Delta 33-891 User Manual download pdf (Page 11)

Fig. 19

Fig. 21

Fig. 20

Fig. 22

4. Loosen cuttinghead clamp knob (J) Fig. 20 and

move cuttinghead (C) to the front of track arm (K).

Loosen track arm locking lever (L), pull out on track arm

index knob (M) and rotate track arm (K) until wrench (F)

is over left table bracket (N). Make certain wrench (F) is

in the vertical position and tighten knob (J) and lever (L)

Fig. 20.

5. Using wrench (D) Fig. 21 as a feeler gage, lower the

track arm assembly by turning handle (P) until wrench (F)

just touches wrench (D). IMPORTANT: Do not raise or

lower track arm any further until table brackets are

adjusted.

6. Loosen track arm locking lever (L) Fig. 20, pull out on

track arm index knob (M) and rotate track arm (K) until

wrench (F) Fig. 22 is directly above rear table bracket (N).

Tighten knob (J) and lever (L) Fig. 20. Using wrench (D)

Fig. 22 as a feeler gage, check to see if the height of the

cuttinghead (C), at the rear of the table bracket (N) is the

same height as the front table bracket.

3. Place wrench (F) Fig. 19, between inner flange (G),

and outer flange (H) and tighten arbor nut (E). Make

certain wrench (F) is above the table surface. If

necessary raise track arm.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

No comments

Delta 33-891 User Manual Page 11