Delta 33-891 User Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
15
OPERATING CONTROLS AND ADJUSTMENTS
Every Delta Radial Saw is thoroughly tested, inspected and accurately aligned before leaving the factory, and when
delivered is ready for operation after it is assembled. However, regardless of the care with which this or any piece of
fine machinery is manufactured, inspected and shipped, it is possible that rough handling in shipment may make minor
adjustments necessary. CAUTION: ALWAYS DISCONNECT SAW FROM POWER SOURCE BEFORE MAKING ANY
ADJUSTMENTS.
Fig. 35
Fig. 36
Fig. 37
Fig. 38
ON/OFF SWITCH
The On/Off Switch (A) Fig. 35, is conveniently placed at
eye level on the front of the overarm. IMPORTANT:
When the tool is not in use, the switch should be
locked in the “OFF” position to prevent unauthorized
use. This is achieved by pressing in and holding the
switch (A) down in the “OFF” position while turning key
(B) to the lock position; then remove key (B).
ADJUSTING OVERARM
COLUMN ASSEMBLY
If side motion develops in the overarm, after extended
use, it can be corrected as follows:
1. DISCONNECT TOOL FROM POWER SOURCE.
2. Loosen hex nuts (A) Fig. 36, and gib adjusting
screws (B) and (C).
3. Adjustment to the column base is made by loosening
hex nuts (D) Fig. 36, tightening or loosening bolts (E),
until column base wraps around column securely and
that the column can be raised or lowered without
binding. Tighten locknuts (D).
4. After column base is adjusted, tighten screws (C)
Fig. 36, against column gib until all side motion
disappears in overarm.
5. Tighten hex nuts (A) and screw (B) Fig. 36.
ADJUSTING YOKE
CLAMP HANDLE
The yoke clamp handle (A) Fig. 37, allows the yoke (B) to
rotate to the rip or cross-cut positions. To reposition the
cuttinghead, push yoke handle (A) to the rear and turn
yoke (B) to desired position; to lock the yoke in position,
pull yoke clamp handle toward you.
If the yoke clamp handle (A) Fig. 37, does not lock the
yoke completely, or does not lock in a convenient
position, the handle can be adjusted as follows:
1. DISCONNECT TOOL FROM POWER SOURCE.
2. Remove blade guard assembly (C) Fig. 37, and saw
blade.
3. Remove rear end plate from track arm and remove
cuttinghead assembly (D) Fig. 37, from track arm.
4. Loosen yoke clamp handle (A) Fig. 37, and remove
cotter pin (E).
5. Turn hex nut (F) Fig. 38, clockwise 60 degrees and
replace cotter pin (E).
6. Replace cuttinghead to track arm and replace items
removed in STEPS 2 and 3.
B
A
B
C
E
A
A
D
D
D
B
A
C
E
F
A
C
E
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Comments to this Manuals

No comments