Delta 33-891 User Manual download pdf (Page 17)

Fig. 45

Fig. 44

Fig. 43

Fig. 42

ADJUSTING BLADE SQUARE

WITH TABLE TOP

The saw blade must be square with the table top in

order to produce accurate work. To check if the blade is

square with the table:

1. DISCONNECT TOOL FROM POWER SOURCE.

2. Remove the blade guard and place the cuttinghead

in a cross-cut position as shown in Fig. 42.

3. Place a steel square (A) Fig. 42, against saw blade

(B) and table, and check to see if the blade (B) is square

with the table. Make certain the square is between the

teeth of the saw blade.

4. If the blade is not square with the table an

adjustment is necessary. Loosen two bolts (C) Fig. 43.

5. Loosen screw (D) Fig. 44, located inside of yoke (E).

6. Hold cuttinghead with left hand as shown in Fig. 45,

loosen bevel clamp handle (F) and tilt the motor until the

saw blade is flush against the square.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

No comments

Delta 33-891 User Manual Page 17