Delta 33-891 User Manual download pdf (Page 8)

ASSEMBLING

CUTTINGHEAD

TO TRACK ARM

1. Raise the track arm assembly (A) Fig. 7, by turning

overarm elevating handle (F) Fig. 2.

2. Remove packing material from around cuttinghead

assembly (B) Fig. 7.

3. Push track arm clamp lever (C) Fig. 7, to the rear until

it rests against stop (D) as shown.

4. Pull out on track arm index knob (E) Fig. 7, and rotate

track arm (F) 90 degrees to the position shown in Fig. 8.

Tighten track arm clamp lever (C) Fig. 8, by pulling it to

front position.

Fig. 7

Fig. 8

Fig. 9

Fig. 11Fig. 10

5. Unscrew and remove blade guard clamping rod (G)

Fig. 9, and remove blade guard assembly (H).

6. Place cuttinghead clamp (J) Fig. 10, in slot on top of

cuttinghead. NOTE: Jaws of cuttinghead clamp must be

open as shown.

7. Lift cuttinghead assembly (B) Fig. 11, and insert

roller bearings (K) into track arm assembly (A) as shown.

NOTE: Make certain the roller bearings (K) are riding on

track rods (L). Push cuttinghead assembly (B) Fig. 11,

into track arm assembly (A) and tighten cuttinghead

clamp (J) Fig. 11.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

Delta 33-891 User Manual Page 8