Delta 33-891 User Manual download pdf (Page 9)

Fig. 15

Fig. 12

Fig. 13

Fig. 14

3. Fig. 15, illustrates the starter box assembled to the

base.

ASSEMBLING STARTER

BOX TO BASE

If you purchased your machine with magnetic starter,

transformer and overload protection, assemble the

starter box to the base, as follows:

1. Assemble bracket (A) to the bottom of the right side

of saw base, as shown in Fig. 13. Place a 1/4" flat

washer onto a 1/4-20x3/4" hex head screw and insert

screw through hole in the bottom of the right side of the

saw base. Place the bracket (A) Fig. 13 onto the screw,

place a 1/4" lock washer onto the screw and thread a

1/4-20 hex nut onto screw and tighten securely.

2. Assemble the starter box (B) Fig. 14, to the right side

of the base. Place a 1/4" lockwasher onto a 1/4-20x1/2"

hex head screw, place a 1/4" flat washer on the screw

and insert the hex head screw (C), through the hole in the

in the bracket (E), and thread screw into the weld nut (D)

Fig. 14, in the back of the starter box (B). Repeat this

process for the two remaining holes in the base and the

starter box.

8. Assemble end cap (N) Fig. 12, to the rear of track

arm assembly (A) and fasten with two 5/16-18x3/4"

button head screws (P) and 5/16" lockwashers (Q)

supplied.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Delta 33-891 User Manual Page 9