Delta 36-841 User Manual download pdf (Page 10)

ASSEMBLING BLADE

GUARD AND SPLITTER

ASSEMBLY

CAUTION: MAKE CERTAIN THE MACHINE IS

DISCONNECTED FROM THE POWER SOURCE.

1. Remove the table insert Fig. 11. Raise the saw arbor,

by turning the locking handle on the front of the saw,

counter clockwise and then turn the wheel on the front of

the saw clockwise as far as it will go, and remove the saw

blade from the machine by following the instructions in

section “REMOVING THE SAW BLADE”.

2. The inside splitter mounting bracket (A) Fig. 12, is

assembled to the inside of the saw and aligned with the

inside blade flange (B) at the factory.

3. To check the alignment, remove screw and fastener

plate (C) Fig. 12. Using a straight edge (D) Fig. 13, check

to see if the splitter bracket (A) is aligned with the inside

blade flange (B). Check both the top and bottom of

bracket (A) with the top and bottom of flange (B).

4. If an adjustment is necessary, loosen two screws (F)

Fig. 14, and adjust splitter bracket (A) until it is aligned

with the inside blade flange (B) Fig. 12. Tighten two

screws (F). Loosely assemble screw and fastener plate

(C), which were removed in STEP 3.

5. Insert threaded end of support rod (G) Fig. 15,

through slot in rear of saw and into hole in rear trunnion

(H). Fasten support rod (G) to trunnion with star washer

and hex nut (J) Fig. 16. NOTE: Thread nut (J) Fig. 16, onto

threads of support rod (G) as much as possible by hand.

Fig. 11 Fig. 12

Fig. 13

Fig. 14

Fig. 15 Fig. 16

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

No comments

Delta 36-841 User Manual Page 10