Delta 36-841 User Manual download pdf (Page 12)

11. Reassemble the saw blade, making certain the teeth

are pointing down at the front of the saw table as shown

in Fig. 23, and assemble the outside blade flange and

arbor nut (X). With open end wrench (Y) on the flats of the

arbor to keep it from turning, tighten arbor nut by turning

box end wrench (Z) counterclockwise.

12. Using a straight edge (A) Fig. 24, make certain the

splitter (P) is aligned with the saw blade (B). Using a

square (C) Figs. 25 and 26, make certain saw blade (B)

Fig. 25, and splitter (P) Fig. 26, are 90 degrees to the table

surface. Once you are certain the splitter is aligned to the

saw blade and table, tighten all splitter mounting

hardware (D) Fig. 26 and recheck alignment.

13. Holding the clear blade guard, lower the saw blade

and assemble the table insert (E) Fig. 27, into the opening

on the saw table.

Fig. 23 Fig. 24

Fig. 25

Fig. 26

Fig. 27

FASTENING MOTOR CORD

TO SAW FRAME

1. IMPORTANT: Turn the blade tilting handwheel

counterclockwise as far as it will go until the saw blade is

in the 45 degree position.

2. IMPORTANT: Turn the blade raising and lowering

handwheel counterclockwise until the blade is at its

lowest position.

3. Fasten motor cord (A) Fig. 27A to the saw frame

cross member (B), using the cable tie (C) supplied with

the saw. CAUTION: Before tightening the cable tie, make

certain that cord (A) is free of any interference from the

motor or saw blade at all possible positions of the motor.

4. After the cable tie is tightened, cut off excess tail of

cable tie (C) Fig. 27A.

Fig. 27A

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

No comments

Delta 36-841 User Manual Page 12