Delta 36-841 User Manual download pdf (Page 17)

Fig. 49 Fig. 50

Fig. 51

Fig. 52

3. Insert two 3/8-24x1" hex head bolts into the two

holes (F) Fig. 49, in the front of saw table and place flat

washer and nut onto bolt from underneath the saw table.

Screw bolts into nuts two full turns, leaving bolt head

extended approximately 1/2" from the table. Note: Make

sure to use only the two holes shown at (F).

4. Insert two 1/4-20x3/4" hex head bolt (E) Fig. 50 into

the front support of the extension table and place flat

washer and nut onto bolt from underneath the extension

table. Screw bolt into nut two complete turns, leaving bolt

head extended approximately 1/4" from the extension

table.

5. Slide the T-SIot guide rail (A) Fig. 51, onto the hex

head of the bolts partially inserted in step 3 and 4 above.

Note: The bolt heads on the saw table slide into the

upper t-slot (B) Fig. 51 and the bolt head on the

extension table slide into the lower t-slot (C) Fig. 52.

6. Slide the guide rail along until the “0” on the Unifence

scale is aligned with the right edge of the saw table. Snug

the hex nuts on the saw and extension table but do not

tighten at this time.

7. Adjust the guide rail (C) Fig. 53, parallel with the saw

table surface by placing a square (H) on the saw table at

both the left and right front ends of the table, with the rule

of the square against the flat surface on top of the guide

rail. The guide rail (C) Fig. 53, can be adjusted up or down

at either end. After you are certain the guide rail is parallel

with the table surface, firmly tighten the two hex nuts that

fasten the guide rail to the table.

Fig. 53

Fig. 54

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

No comments

Delta 36-841 User Manual Page 17