Delta 36-841 User Manual download pdf (Page 18)

8. Move the square (H) Fig. 54, to the end of the

Unifence table and check to make certain the same

distance is maintained from the top surface of the

extension table (K) to the top surface of the guide rail (C).

Move the front table support (L) Fig. 55, against the guide

rail (C), and tighten the 1/4-20 nuts (M). Tighten two wood

screws, one of which is shown at (N) Fig. 55, that fasten

the Unifence table to the guide rail.

Fig. 55

ASSEMBLING UNIFENCE

RAIL STOP

1. Insert 1/4-20x2" bolt (A) through hole into one side of

bracket (B) Fig. 56.

2. Place one washer (C), on bolt (A), and slide bolt

through flip stop (D) Fig. 56.

3. Place the other washer (C), on bolt (A), and slide bolt

(A) through other side of bracket (B) Fig. 56.

4. Screw the lock nut (E) onto bolt (A) and tighten until

the flip stop will stay up.

5. Insert bolt (F) through bracket (B) as shown and

screw knob (G) onto bolt (F) approximately 3 complete

turns. Fig. 56.

6. To attach rail stop to unifence as shown in Fig. 58.

7. Using a rubber mallet (P) Fig. 57, or a hammer and a

block of wood, gently tap end cap (R) into both ends of

the guide rail. NOTE: To avoid damage to the guide rail,

DO NOT use a metal hammer directly against the guide

rail.

Fig. 56

Fig. 57

Fig. 58

Fig. 59

SETTING FLIP STOP

1. The Flip Stop Assembly Fig. 58, can be set to any

number of positions along the guide rail providing a

quick stop setting for the Unifence body by loosening

knob (G) and sliding the stop along the rail to the desired

position and re- tighten.

2. Any number of stops can be purchased and installed

to provide time saving quick stop setting for the Unifence

body.

3. If flip stop does not retract fully the bolt (F) Fig. 58,

may have to be repositioned in the rail slot to allow the

flip stop to retract fully. If bolt (F) needs to be

repositioned, just slide the bolt out of the rail and turn the

head of the bolt one third of a turn (one flat) and slide

back into rail, repeat this until the bolt is in the right

position for the flip stop to retract fully. Fig. 59.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Comments to this Manuals

No comments

Delta 36-841 User Manual Page 18

Comments to this Manuals

Related products and manuals for Power saws Delta 36-841