Delta 36-841 User Manual download pdf (Page 20)

ASSEMBLING FENCE TO

UNIFENCE BODY

1. The fence (A) can be assembled to clamp plate (B) in

either the horizontal position as shown in Fig. 66, or the

vertical position as shown in Fig. 67. Make certain the

two lock knobs, one of which is shown at (C), are loose

and slide fence (A) onto clamp plate (B) as shown. Then

tighten the two lock knobs (C).

2. For most normal ripping operations, the bottom of

the fence should be positioned slightly above the table

surface. Loosen two lock knobs (C) Fig. 68, and place a

thin object such as a ruler (D) between the table and

fence, as shown. Then tighten two lock knobs (C).

Fig. 66

Fig. 67

Fig. 68

Fig. 69

FENCE OPERATION

1. Before operating fence, make sure the fence is ad-

justed parallel to miter gage slot, as explained later on in

this manual.

2. For most normal ripping operations of standard size

lumber, the fence is used in the vertical position, as

shown in Fig. 69.

3. When ripping thin stock, it is sometimes more

convenient to use the fence in the horizontal position, as

shown in Fig. 70.

4. To move the fence along the guide rail, lift up clamp

lever (A), as shown in Fig. 71, slide fence to desired

position on the rail, and push down on clamp lever (A) to

lock fence in place.

Fig. 70

Fig. 71

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

No comments

Delta 36-841 User Manual Page 20