Delta 36-841 User Manual download pdf (Page 22)

sticks may interfere with the blade guard. That flat

pushboard can be made as shown in Fig. 124A.When

ripping material with a veneer facing that extends over the

material, the fence (A) should be in the horizontal position

with the veneer (B) extending over the lip of the fence, as

shown in Fig. 76.

When ripping material with a veneer facing and the

material is not thick enough for the veneer to extend over

the lip of the fence or if the veneer facing (B) is on both

sides of the material, as shown in Fig. 77, the fence can

be positioned slightly above the surface of the table. The

veneer can be placed between the fence and the table or

the veneer can straddle the fence with the material solidly

against the fence.

Fig. 76

Fig. 77

Fig. 78

Fig. 79

ADJUSTING FENCE PARALLEL

TO MITER GAGE SLOTS

The fence (A) Fig. 78, should be adjusted so it is parallel

to miter gage slots (B). To check and adjust, move the

fence (A) until the bottom front edge of the fence is in line

with the edge of the miter gage slot as shown, and push

down on fence clamping lever (C). Check to see if the

fence is parallel to the miter gage slot the entire length of

the table. If the rear of the fence must be moved, slightly

tighten or loosen one of the adjustment plugs (D) or (E)

Fig. 78, using the arbor wrench or a 7/8" wrench, until the

fence is parallel with the miter gage slot. IMPORTANT:

DO NOT OVER-TIGHTEN PLUGS (D) AND (E) FIG. 78.

VERY LITTLE MOVEMENT OF THESE PLUGS IS

NECESSARY WHEN ADJUSTING THE FENCE

PARALLEL WITH THE MITER GAGE SLOT.

ADJUSTING FENCE 90

DEGREES TO TABLE

The fence must be adjusted so that the face of fence (A)

Fig. 79, is 90 degrees to the table. To check if the fence

is 90 degrees to the table, place a square (B) on the table

with one end of the square against the fence, as shown.

If an adjustment is necessary, tighten or loosen one of

two screws (C) or (D) until the fence is 90 degrees to the

table.

IMPORTANT: VERY LITTLE MOVEMENT OF THESE

SCREWS (C) AND (D) IS NECESSARY TO MAKE THIS

ADJUSTMENT.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Comments to this Manuals

No comments

Delta 36-841 User Manual Page 22

Comments to this Manuals

Related products and manuals for Power saws Delta 36-841