Delta 36-841 User Manual download pdf (Page 23)

Fig. 80

Fig. 81

ADJUSTING CLAMPING

ACTION OF FENCE

LOCKING HANDLE

When the fence locking handle (A) is pushed to the down

position, as shown in Fig. 80, the fence body (B) should

be completely clamped to the guide rail. If the fence body

(B) is not completely clamped to the guide rail when the

handle (A) is in the position shown in Fig. 80, lift up on

locking handle (A) Fig. 81, and slightly tighten two

adjustment plugs (C) using the arbor wrench or 7/8"

wrench. Adjustment plugs (C) should be tightened an

equal amount. Check to see if the fence body (B) is

completely fastened to the rail by pushing down on

locking lever (A). Adjust further if necessary.

IMPORTANT: AFTER ADJUSTING THE CLAMPING

ACTION OF THE FENCE LOCKING HANDLE, CHECK

TO SEE IF THE FENCE IS PARALLEL TO THE MITER

GAGE SLOT AND ADJUST IF NECESSARY.

RIPPING ON LEFT SIDE OF

SAW BLADE

In some cases it may be desirable to use the fence on the

left side of the saw blade. This is accomplished by

repositioning the fence (A) Figures 82 and 83, fence

clamp bar (B) and lock knobs (C) so that the fence (A) will

be attached to the right side of the fence body, as shown

in Fig. 83. The complete fence assembly (D) Fig. 83, can

easily be moved to the left side of the saw table.

Fig. 82

Fig. 83

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

No comments

Delta 36-841 User Manual Page 23