Delta 36-841 User Manual download pdf (Page 26)

ASSEMBLING TABLE LEGS

TO EXTENSION TABLE

1. Position the two legs, at the inside of one end of the

extension table, mark the position of the eight holes to be

drilled into the bottom of the table, Fig. 92. Remove the

two legs and using a 1/16" drill bit, drill the eight holes

1/2" deep. Replace the two legs and fasten to the bottom

of the table using the eight 3/4" long wood screws

supplied.

2. Fasten the leg bracket (L) Fig. 93, to the end piece (J)

of the table using the two 1-1/2" long flat head Phillips

screws, flat washers and hex nuts. Fasten the remaining

leg to the extension table in the same manner.

Fig. 92 Fig. 93

ASSEMBLING EXTENSION TABLE

TO FRONT AND REAR RAILS

1. Place table assembly (N) Fig. 95, in position between

the two rails, as shown. Make sure end of table (N) is flush

against extension wing (P). Using a straight edge make

sure table (N) is in the same plane and level with saw table

(P). Lightly tap table up or down and adjust leveling

screws (R) Fig. 96, in bottom of legs to accomplish this.

When the table (N) Fig. 95, is level and in the same plane

with saw table (P), drill 1/4" through holes (S) Fig. 95

through the front and rear of the extension table using the

holes provided in rails as template.

2. After the holes have been drilled in the edge of the

front and rear extension table board, fasten both front and

rear rail to table using the 1-1/2" flat head Phillips screws,

flat washers, and hex nuts (S) Fig. 95.

Fig. 95

Fig. 96

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

No comments

Delta 36-841 User Manual Page 26