Delta 36-841 User Manual download pdf (Page 28)

ADJUSTING FENCE

PARALLEL TO MITER

GAGE SLOTS

NOTE: Delta table saws have been aligned at the factory

so that the miter gage slots in the table are parallel with

the saw blade. It is recommended, however, to check

and make certain this alignment is correct before adjust-

ing the fence parallel to the miter gage slot as follows:

The fence (A) Fig. 103, must be adjusted so it is parallel

to the miter gage slots (B). To check and adjust, move

fence (A) until the bottom edge of the fence is in line with

the edge of one of the miter gage slots as shown, and

push down on the fence clamping lever (C). Check to see

if the fence (A) is parallel to the miter gage slot, the entire

length of the table. If an adjustment must be made, lift up

fence locking lever (C) and raise fence up off the guide

tube, as shown in Fig. 104. Slightly tighten or loosen one

of the two adjusting screws (D) or (E) Fig. 104, using a

3/16" alIen wrench (F), not supplied. Replace the fence

on the guide tube and check again to see if the edge of

the fence is parallel with the miter gage slot the entire

length of the slot. Repeat this adjustment until you are

sure the fence is parallel with the miter gage slot.

IMPORTANT: VERY LITTLE MOVEMENT OF SCREWS

(D) AND (E) IS NECESSARY TO ADJUST THE FENCE

PARALLEL WITH THE MITER GAGE SLOT.

ADJUSTING CLAMPING

ACTION OF FENCE

LOCKING HANDLE

When the fence locking handle (A) is pushed to the down

position, as shown in Fig. 105, the fence assembly (B)

should be completely clamped to the guide tube (C). If

the fence assembly (B) is not completely clamped to the

guide tube (C) when the handle (A) is pushed down, as

shown in Fig. 105, lift up handle (A) and raise fence

assembly (B) up off the guide tube (C). Slightly tighten

the two adjusting screws (D) and (E) Fig. 104, using the

3/16" allen wrench (F) not supplied. Adjusting scr

ews (D)

and (E) Fig. 104. should be tightened an equal amount.

Replace fence onto the guide tube and recheck to see if

the fence assembly (B) Fig. 105, is completely tightened

to the guide tube (C) with the locking handle (A) pushed

down. Adjust further if necessary.

IMPORTANT: AFTER ADJUSTING THE CLAMPING

ACTION OF THE FENCE LOCKING HANDLE, CHECK

TO SEE IF THE FENCE IS PARALLEL TO THE MITER

GAGE SLOT AND ADJUST IF NECESSARY.

Fig. 103

Fig. 104

Fig. 105

FENCE LUBRICATION

1. Apply paste wax to fence and guide tube sliding sur-

faces weekly.

2. Apply grease to cam lock (A) Fig. 102, and cam foot

(B) occasionally to prevent wear.

Fig. 102

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Comments to this Manuals

No comments

Delta 36-841 User Manual Page 28

Comments to this Manuals

Related products and manuals for Power saws Delta 36-841