Delta 11-990 Instruction Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 15
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
11
STARTING AND STOPPING
DRILL PRESS
The switch (A) Fig. 21, is located on the front of the drill
press head. To turn the drill press “ON” move the switch
to the up position. To turn the drill press “OFF” move the
switch to the down position.
LOCKING SWITCH IN
THE “OFF” POSITION
IMPORTANT: When the tool is not in use, the switch
should be locked in the “OFF” position to prevent
unauthorized use. This can be done by grasping the
switch toggle (B) and pulling it out of the switch, as
shown in Fig. 22. With the switch toggle (B) removed,
the switch will not operate. However, should the switch
toggle be removed while the drill press is operating, the
switch can be turned “OFF” once, but cannot be
restarted without inserting the switch toggle (B).
Fig. 22
B
Fig. 21
A
Fig. 23
Fig. 24
A
B
1. The table can be raised or lowered on the drill press
column by loosening the table clamp handle (A) Fig. 23,
and turning the table raising and lowering handle (B) Fig.
24. After the table is at the desired height, tighten handle
(A) Fig. 23. NOTE: Final positioning of the drill press table
should always be from the bottom to the up position.
2. The table can be rotated 360 degrees on the column
by loosening clamp handle (A) Fig. 23, rotate table to
desired position and tighten clamp handle (A).
TABLE ADJUSTMENTS
MAGNETIC BASE LAMP
The magnetic base lamp operates independently from
the drill press. To turn the lamp “ON” and “OFF”, rotate
switch (B) Fig. 20.
OPERATING CONTROLS AND ADJUSTMENTS
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments