Part No. 1343761 - 12-16-04DELTA ACCESSORYMODEL 17-935 & MODEL 17-924MORTISING ATTACHMENTCARTON CONTENTSMortising Attachment Assembled1. Fence2. L
2ASSEMBLING THE CHISEL HOLDER1. Loosely thread the knob (A) Fig. 1 into the bottom of the hole of the chisel holder (B) (See Fig. 2).2. Install the sp
3Disconnect the machine from the power source.THE FOLLOWING INSTRUCTIONS ARE FOR THE DELTA 15" UTILITY DRILL PRESSES.1. Lower the spindle (A) Fig
4THE FOLLOWING INSTRUCTIONS ARE FOR THE DELTA 17-900 16-1/2" DRILL PRESS.Disconnect the machine from the power source.NOTE: This unit requires NO
5ATTACHING THE WORKPIECE HOLD-DOWN - ALL UNITS1. Attach the vertical shaft (X) Fig. 15 to the fence, using the supplied wrench (H).NOTE: Place the fla
6SPINDLE SPEEDSThe correct spindle speed depends on the size of the bit and the hardness of the wood. Your best cuts are generallyin the range of 650
7MORTISING CHISELS WITH 5/8" X 1-1/2" SHANKCat. No.SizeDepth Capacity17-91217-91317-91417-9151/4" x 1/4"5/16" x 5/16"3/8
8NOTES
Comments to this Manuals