Delta 14-651 Instruction Manual

INSTRUCTION MANUALHollow ChiselMortiser(Model 14-651)PART NO. 910209 - 04-28-04Copyright © 2004 Delta MachineryTo learn more about DELTA MACHINERY vis

105. Adjust the flat portion of the bit to a minimum of1/16" below the bottom of the chisel. Certain typesof wood may require an increase in this

11NOTE: Reverse the procedure to remove the column extension.Fig. 20ABCOPERATING CONTROLS AND ADJUSTMENTSThe power switch is located on the left side

12HOLD-DOWNThe hold-down (C) Fig. 25 prevents the workpiece (E)from lifting as the chisel is lifted out of the hole. To adjustthe hold-down, loosen th

13The column (A) Fig. 29 can be rotated 180 degrees for special cuts off of the table. To rotate the column, remove fourscrews, two of which are shown

14A complete line of accessories is available from your Delta Supplier, Porter-Cable • Delta Factory Service Centers,and Delta Authorized Service Stat

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marquessuivantes sont de

2Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation

3GENERAL SAFETY RULES1. FOR YOUR OWN SAFETY, READ THE INSTRUCTIONMANUAL BEFORE OPERATING THE MACHINE.Learning the machine’s application, limitations,

4ADDITIONAL SAFETY RULES FORHOLLOW CHISEL MORTISERS1. DO NOT OPERATE THIS MACHINE until it iscompletely assembled and installed according tothe instru

A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected with a 20 Amp tim

6EXTENSION CORDSFOREWORDDelta Model 14-651 is easier to operate than a conventional drill press equipped with a mortising attachment. The model14-651

7CARTON CONTENTSFig. 21. Mortiser2. Tool and Chisel Holder3. Chuck Key / Wrench4. Column Extension5. Hydraulic Cylinder6. Handle7. Extended hold-down

8TOOL AND CHISEL HOLDER1. Attach the tool and chisel holder (A) Fig. 7 to the back of the column, using the two M6x1x25mm screws (B) andM6 lockwashers

9If during operation there is any tendency for themortiser to tip over, slide or walk on the supportingsurface, the base must be secured to the suppo