INSTRUCTION MANUALPART NO. A10354 - 04-06-05Copyright © 2005 Delta MachineryTo learn more about DELTA MACHINERY visit our website at: www.deltamachine
105. Re-install the ring (E) Fig. 9 (removed in STEP 1).IMPORTANT: DO NOT push the ring (E) Fig. 9 all the way downon the the raising rack (F). Make c
11IMPORTANT: Make certain that the spindle taper (Q) Fig. 16 and the tapered hole in the chuck (R) are clean and freeof any grease, lacquer, or rust-p
125. Thread the two speed-changing levers (W) Fig. 22 into the speed changing hub.6. Thread the speed range-changing lever (X) Fig. 23 into the hub.Fi
13LOCKING SWITCH IN THE “OFF” POSITIONIMPORTANT: When the machine is not in use, the switch should be locked in the “OFF” position to prevent unauthor
1. Insert the bit into the chuck.2. Lower the chuck (C) Fig. 34, and the drill bit to your chosendepth by rotating the pinion shaft handles (D). Lock
15ADJUSTING THE SPINDLE RETURN SPRINGThe spindle will automatically return slowly to its upper position when the handle is released. The spindle retur
16Fig. 39ABDCNOTE: Use drill bits with a shank of 1/2" or less in diameter.DISCONNECT MACHINE FROM POWER SOURCE.1. Insert the smooth end of drill
17MAINTENANCETROUBLESHOOTINGFor assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or callthe DEL
18PARTS, SERVICE OR WARRANTY ASSISTANCEAll Delta Machines and accessories are manufactured to high quality standards and are serviced by a networkof P
19Two Year Limited New Product WarrantyDelta will repair or replace, at its expense and at its option, any new Delta machine, machine part, or machine
2TABLE OF CONTENTSRead and understand all warnings and operating instructions before using any tool or equipment. Whenusing tools or equipment, basic
The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marquessuivantes sont de
3Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation
4GENERAL SAFETY RULESREAD AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFOREUSING THIS EQUIPMENT. Failure to follow all instructions listed
5SAVE THESE INSTRUCTIONS. Refer to them often and use them to instruct others.ADDITIONAL SPECIFIC SAFETY RULES1. DO NOT OPERATE THIS MACHINE until it
You can have your drill press converted to 230 voltoperation.A qualified electrician must perform this conversion. Shouldyou desire to have your drill
7EXTENSION CORDSUse proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extensioncord which has a 3-prong groun
812345 67891011A11B121314151617181. Drill Press Head2. Column and Table Raising Rack3. Table/Column Bracket4. Lock Lever for Column Bracket 1/2-13x1-1
9ASSEMBLYASSEMBLY TOOLS REQUIREDASSEMBLY TIME ESTIMATE1. Attach the column (A) Fig. 3 to the base (B) usingthe four M10x40mm hex head screws (C), thre
Comments to this Manuals