Delta 17-965 Instruction Manual download pdf (Page 6)

A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and should be

protected with a 20 Amp time lag fuse. If an extension cord is used, use only 3-wire extension cords which have 3-prong

grounding type plugs and matching receptacle which will accept the machine’s plug. Before connecting the machine to the

power line, make sure the switch (s) is in the “OFF” position and be sure that the electric current is of the same characteristics

as indicated on the machine. All line connections should make good contact. Running on low voltage will damage the

machine.

DO NOT EXPOSE THE MACHINE TO RAIN OR OPERATE THE MACHINE IN DAMP LOCATIONS.

Fig. A Fig. B

GROUNDED OUTLET BOX

CURRENT

CARRYING

PRONGS

GROUNDING BLADE

IS LONGEST OF THE 3 BLADES

GROUNDED OUTLET BOX

GROUNDING

MEANS

ADAPTER

2. Grounded, cord-connected machines intended for

use on a supply circuit having a nominal rating less than

150 volts:

If the machine is intended for use on a circuit that has an

outlet that looks like the one illustrated in Fig. A, the machine

will have a grounding plug that looks like the plug illustrated

in Fig. A. A temporary adapter, which looks like the adapter

illustrated in Fig. B, may be used to connect this plug to a

matching 2-conductor receptacle as shown in Fig. B if a

properly grounded outlet is not available. The temporary

adapter should be used only until a properly grounded outlet

can be installed by a qualified electrician. The green-colored

rigid ear, lug, and the like, extending from the adapter must

be connected to a permanent ground such as a properly

grounded outlet box. Whenever the adapter is used, it must

be held in place with a metal screw.

NOTE: In Canada, the use of a temporary adapter is not

permitted by the Canadian Electric Code.

1. All grounded, cord-connected machines:

In the event of a malfunction or breakdown, grounding

provides a path of least resistance for electric current to

reduce the risk of electric shock. This machine is equipped

with an electric cord having an equipment-grounding

conductor and a grounding plug. The plug must be plugged

into a matching outlet that is properly installed and grounded

in accordance with all local codes and ordinances.

Do not modify the plug provided - if it will not fit the outlet,

have the proper outlet installed by a qualified electrician.

Improper connection of the equipment-grounding

conductor can result in risk of electric shock. The

conductor with insulation having an outer surface that is

green with or without yellow stripes is the equipment-

grounding conductor. If repair or replacement of the electric

cord or plug is necessary, do not connect the equipment-

grounding conductor to a live terminal.

Check with a qualified electrician or service personnel if the

grounding instructions are not completely understood, or if

in doubt as to whether the machine is properly grounded.

Use only 3-wire extension cords that have 3-prong grounding

type plugs and matching 3-conductor receptacles that

accept the machine’s plug, as shown in Fig. A.

Repair or replace damaged or worn cord immediately.

POWER CONNECTIONS

MOTOR SPECIFICATIONS

Your machine is wired for 115 volt, 60 HZ alternating current. Before connecting the machine to the power source, make

sure the switch is in the “OFF” position.

GROUNDING INSTRUCTIONS

THIS MACHINE MUST BE GROUNDED WHILE IN USE TO PROTECT THE OPERATOR FROM

ELECTRIC SHOCK.

IN ALL CASES, MAKE CERTAIN THAT THE

RECEPTACLE IN QUESTION IS PROPERLY

GROUNDED. IF YOU ARE NOT SURE,

HAVE A QUALIFIED ELECTRICIAN CHECK

THE RECEPTACLE.

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

Comments to this Manuals

No comments

Delta 17-965 Instruction Manual Page 6

Comments to this Manuals

Related products and manuals for Power tools Delta 17-965