Delta 17-965 Instruction Manual download pdf (Page 9)

ASSEMBLY

ASSEMBLY TOOLS REQUIRED

ASSEMBLY TIME ESTIMATE

1. Attach the column (A) Fig. 3 to the base (B) using the

four 1-3/4" bolts (C), three of which are shown.

Loosely thread the locking lever (D) into the table

mounting bracket (E). Loosely thread the remaining

locking lever (F) Fig. 4 into the split of the table

mounting bracket (E).

2. Insert the table (G) Fig. 4 into the table mounting

bracket (E) Fig. 3 and tighten the lever (D) Fig. 4 to

lock the table in position. Tighten the locking lever

(F) Fig. 4 to lock table-raising mechanism on the

column.

3. Attach the table adjusting handle (H) Fig. 4 to the

table mounting bracket (E).

4. Carefully position the drill press head (J) Fig. 5 on the

column (A) as far as it will go. Align the drill press

head (J) Fig. 5 and the table (G) Fig. 4 with the base

of the drill press, and tighten the locking lever (K) and

set screw (L) with the supplied hex wrench (M).

5. Thread the three pinion shaft handles (N) Fig. 6 into the three holes in the pinion shaft (P).

6. IMPORTANT: Make certain the spindle (R) Fig. 7, and chuck (S) are free of any grease, lacquer or rust preventive

coatings.

NOTE: If necessary, household oven cleaner can effectively remove these coatings from the spindle and chuck. Carefully

follow the manufacturer’s safety rules regarding its use.

7. Insert the chuck (S) Fig. 7 on the spindle (R) as far as it will go.

Fig. 3

Fig. 4

Fig. 5

Fig. 6

Fig. 7

For your own safety, do not connect the machine to the power source until the machine is

completely assembled and you read and understand the entire instruction manual.

3mm Hex Wrench (Supplied) 5mm Hex Wrench (Supplied) Adjustable Wrench

The assembly time for this unit is approximately 1-2 hours.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

No comments

Delta 17-965 Instruction Manual Page 9