Delta 22-540 Instruction Manual

INSTRUCTION MANUAL12” Portable Planer(Model 22-540)PART NO. 901606 (013)Copyright © 2001 Delta MachineryESPAÑOL: PÁGINA 17To learn more about DELTA MA

Fig. 17Fig. 18Fig. 19Fig. 20LEVELINGEXTENSION TABLESFor optimum performance, the extension tables, one ofwhich is shown at (A) Fig. 17, must be level

115. If an adjustment to one or both knives is necessary, slightly loosen the seven locking screws, six of which areshown at (C) Fig. 21, by turning t

Fig. 23LIFTING STRAPSYour planer is provided with two lifting straps (A) Fig. 23,located on the top of the planer, for ease in transportingthe planer.

13MAINTENANCEFig. 26Fig. 27Fig. 28Fig. 30Fig. 29BRUSH INSPECTIONAND REPLACEMENTCAUTION: BEFORE INSPECTING THE BRUSHES, DIS-CONNECT THE TOOL FROM THE P

Delta Building Trades and Home Shop MachineryTwo Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machin

15NOTES

16NOTES

The following are trademarks of PORTER-CABLE DELTA Corporation (Las siguientes son marcas registradas de PORTER-CABLE S.A.):BAMMER®, INNOVATION THAT W

2SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards in

3ADDITIONAL SAFETY RULES FOR PLANERS1. DO NOT operate the tool until it is completelyassembled and installed according to the instructions.2. IF YOU A

4CONNECTING TOOL TO POWER SOURCEPOWER CONNECTIONSA separate electrical circuit should be used for your tools. This circuit should not be less than #12

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug a

6UNPACKING AND CLEANINGCarefully unpack the tool and all loose items from the shipping container(s). Peel protective film from the table surface.Remo

7ASSEMBLY INSTRUCTIONSFig. 4Fig. 5Fig. 6ASSEMBLING RAISING ANDLOWERING HANDLE1. Assemble raising and lowering handle (A) Fig. 4, toshaft (B) and faste

8Fig. 7Fig. 8Fig. 9ASSEMBLINGCHIP DEFLECTOR1. Assemble chip deflector (A) Fig. 7, to the planer byinserting end of chip deflector over the top of thec

9OPERATING CONTROLS AND ADJUSTMENTSFig. 13Fig. 14Fig. 15Fig. 16STARTING ANDSTOPPING PLANERThe “ON/OFF” switch (A) Fig. 13, is located on the frontof t