Delta 23-665 Instruction Manual

INSTRUCTION MANUAL6" Thin-Line Bench Grinderwith Flexible Lamp(Model 23-665)PART NO. 900463 (011)Copyright © 2001 Delta MachineryESPAÑOL: PÁGINA

10PARTS, SERVICE OR WARRANTY ASSISTANCEDelta Building Trades and Home Shop MachineryTwo Year Limited WarrantyDelta will repair or replace, at its expe

2SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards in

3ADDITIONAL SAFETY RULES FOR GRINDERS1. DO NOT OPERATE your tool until it is completely assem-bled and installed according to the instructions.2. IF Y

4UNPACKING AND CLEANINGCarefully unpack the tool and all loose items from the carton. Remove the protective coating from all unpainted parts.This coat

5HARDWARE ILLUSTRATIONHardware Illustrated in actual sizeFig. 211/16" Flat Washer (2)3/4" Flat Washer (4)5/16 - 18 x 1/2" Hex Head Scre

6ASSEMBLYASSEMBLINGTOOL RESTS1. Assemble the v-grooved tool rest (A) Fig. 3, to theinside of the right wheel guard using two 5/16-18x5/8"hex head

7Fig. 6Fig. 73. Assemble long end of eye shield mounting rod (F)Fig. 7, to the side of each wheel guard using bracket (J),3/8" lockwasher and loc

8Fig. 11EXTENSION CORDSUse proper extension cords. Make sure your extensioncord is in good condition and is a 3-wire extension cordwhich has a 3-prong

9Fig. 12AFLEXIBLE LAMPThe flexible lamp operates independently of the grinder.To turn the lamp on and off, rotate switch (A) Fig. 12.WARNING: To reduc