INSTRUCTION MANUAL14" Wood CuttingBand Saw(28-293 & 28-299)PART NO. 426-02-651-0040 - 09-30-01Copyright © 2001 Delta MachineryTo learn more a
10ADJUSTING BLADE TENSIONCAUTION: DISCONNECT TOOL FROM POWER SOURCE.A series of graduations is located on the back of the upperwheel slide bracket. Th
11ADJUSTING THE UPPER BLADE GUIDES AND BLADE SUPPORT BEARINGAdjust the upper blade guides and blade support bearings ONLYAFTER the blade has the corre
12BAND SAW BLADESA bandsaw blade is a delicate piece of steel that is subjected to a great deal of strain. Proper blade care results inoptimal perform
13Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which
14NOTES
15NOTES
The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): BAMMER®,INNOVATION THAT WORKS®, JETST
2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, there are cer-tain
3ADDITIONAL SAFETY RULES FOR BAND SAWSCONNECTING TOOL TO POWER SOURCEPOWER CONNECTIONSA separate electrical circuit should be used for your tools. Thi
44Fig. 1 Fig. 2Fig. 3MINIMUM GAUGE EXTENSION CORDRECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC TOOLSAmpere Total Length Gauge ofRating Volts of C
5OPERATING INSTRUCTIONSFOREWORDDelta Models 28-293 and 28-299 are 14" Band Saws. These tools are equipped with a 1 HP, 115V guarded drip-proof mo
ATTACHING THE BELTAND THE PULLEY GUARD1. DISCONNECT TOOL FROM POWER SOURCE.2. Attach the belt and pulley guard (A) to the top of thestand (B) Fig. 10
7ATTACHING THE SWITCHA push-button switch (mounted in a switch box), and a cordset are supplied with the unit. To attach the switch to the bandsaw arm
8Fig. 17Fig. 186. Remove the screw and cable clamp (E) Figs. 15 and 16 fromthe lower arm of the band saw.7. Insert the switch cord (F) Fig. 16, into t
9Fig. 19TABLE INSERTPlace the table insert (A) Fig. 19 in the hole provided in thetable. Engage the protrusion on the insert in the indents (B) inthe
Comments to this Manuals