14" Wood CuttingBand Saw(Models 28-241 & 28-299A)426-02-651-0049 - 06-24-02Copyright © 2002 Delta MachineryINSTRUCTION MANUALTo learn more ab
10ADJUSTING THE UPPER BLADE GUIDES AND BLADE SUPPORT BEARINGAdjust the upper blade guides and blade support bearings ONLY AFTER the blade has the corr
11ADJUSTING LOWER BLADE GUIDESAND BLADE SUPPORT BEARINGAdjust the lower blade guides and blade support bearing after the theupper guides and bearing h
12OPERATING THE BAND SAWCAUTION: DISCONNECT TOOL FROM POWER SOURCE.Before starting the tool, make all adjustments and put all guards in place. Turn th
13ACCESSORIESA complete line of accessories is available from your Delta Supplier, Porter-Cable • Delta Factory Service Centers,and Delta Authorized
14Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which
15NOTES
The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): Auto-Set®, BAM-MER®, B.O.S.S.®, Build
2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha
ADDITIONAL SAFETY RULES FORBAND SAWSWARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.1. DO NOT OPERATE THIS MACHINE UNTIL
4POWER CONNECTIONSA separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected
5Use proper extension cords. Make sure your extensioncord is in good condition and is a 3-wire extension cordwhich has a 3-prong grounding type plug a
6ATTACHING MOTOR PULLEYAttach the motor pulley (A) Fig. 7 to the motor shaft, makingsure that the set screw (B) in the motor pulley engages withthe ke
7Fig. 8ATTACHING BAND SAWTO THE STANDCAUTION: The band saw is very heavy. Use a helperwhen attaching the saw to the stand.Attach the band saw to the s
8Fig. 17Fig. 18STARTING AND STOPPING SAWTo start the tool, press the “START” button (K) Fig. 17. To stop the tool, press the “STOP” button (L) Fig. 17
9TILTING THE TABLE1. The table on the band saw can be tilted 45 degrees to theright and 10 degrees to the left. To tilt the table to the right,loosen
Comments to this Manuals