INSTRUCTION MANUAL3 H.P. Single-StageDust Collector(Model 50-852, three phase)(Model 50-853, single phase)PART NO. 902108 - 06-27-02Copyright © 2002 D
10Fig. 26Fig. 284. Pull up on each retaining clip (A) Fig. 26, and insertthe dust collection bag (B) underneath each retaining clipto hold the dust co
11Fig. 29Fig. 30Fig. 31ASSEMBLING DUST INTAKEPORT TO BLOWER ANDMOTOR ASSEMBLYMAKE CERTAIN THE DUST COLLECTOR ISDISCONNECTED FROM THE POWER SOURCE.1. A
12Fig. 32Fig. 33Fig. 34Fig. 35MODEL 50-853SINGLE PHASEINSTALLATIONYour dust collector is supplied with a motor andcontroller; however, it is not suppl
13OPERATING CONTROLSON/OFF SWITCH(Model 50-852)The “on/off” switch is located on the side of the motorstand. To turn the dust collector “ON”, push but
14NOTES
15Printed in U.S.A.PARTS, SERVICE OR WARRANTY ASSISTANCEAll Delta Machines and accessories are manufactured to high quality standards and are serviced
The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): Auto-Set®,BAMMER®, B.O.S.S.®, Builder
2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha
3ADDITIONAL SAFETY RULES FORDUST COLLECTORSWARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.1. DO NOT OPERATE THIS MACHINE
4UNPACKING AND CLEANINGCarefully unpack the tool and all loose items from the shipping container(s). Remove the protective coating from allunpainted s
5Fig. 5Fig. 6Fig. 7Fig. 8ASSEMBLING CASTERASSEMBLIES TO BASEAlign the holes in caster assembly (A) Fig. 5, with fourholes in support stand (B) located
6Fig. 9Fig. 10Fig. 11Fig. 124. Apply a bead of silicone sealant around flange ofchute (F) Fig. 9. Align holes in ten-hole gasket (G) Fig. 9,with mount
7Fig. 13Fig. 14Fig. 15Fig. 177. Apply a bead of silicone sealant around flange ofchute (H) Fig. 14. Align holes in eight-hole gasket (K) Fig.14, with
8Fig. 18Fig. 19Fig. 21Fig. 2011. Align two mounting holes in the top of drum supportarm (T) Fig. 18, with two pre-drilled holes in drum (N)and fasten
9Fig. 22Fig. 23Fig. 24Fig. 25ASSEMBLING FILTERAND DUST COLLECTIONBAGS TO DRUM1. Hook the loop on the top of filter bag (A) Fig. 22, ontofilter bag sup
Comments to this Manuals