Delta 36-650 Instruction Manual download pdf (Page 11)

MOTOR TO MOTOR

MOUNTING PLATE

DISCONNECT MACHINE FROM POWER

SOURCE.

Assemble motor (A) to motor mounting plate (B) as shown

in Fig. 16. Align the four mounting holes in the motor

with the four holes in the mounting plate. Insert a 5/16-

18x3/4" carriage bolt (C), through the hole in motor and

then through the hole in the motor mounting plate, place

a 5/16" flat washer (D) onto the carriage head bolt, place

a 5/16" external tooth washer (E) onto the carriage head

bolt, thread a 5/16-18 hex nut (F) onto the carriage head

bolt. Repeat this process for the three remaining holes in

the motor and the motor mounting plate.

NOTE: Do not completely tighten the hex nuts at this

time.

Fig. 16

MOTOR AND MOTOR

MOUNTING PLATE TO SAW

DISCONNECT MACHINE FROM POWER

SOURCE.

1. Insert a pin (X) Fig. 17, into the holes in each side of

bracket (B). NOTE: INSERT THE TAPERED END OF

PIN (X) FIG. 17, THROUGH THE INSIDE HOLE OF

BRACKET (B).

2. Assemble spring (Y) Fig. 17, onto the non tapered

end of each pin (X) as shown.

3. Position motor and motor mounting plate (A) Fig. 17,

below bracket (B) to allow bracket arm to slide through

large opening in motor mounting plate (A).

4. Depress pins (X) Fig. 18, on both sides of bracket (B)

and rotate motor mounting plate (A) until pins (X) are

engaged in holes (D) Fig. 17, of motor mounting plate

(A).

5. Fig. 19, illustrates the motor and motor mounting

plate assembled to the rear of the saw.

Fig. 17

Fig. 18

Fig. 19

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

No comments

Delta 36-650 Instruction Manual Page 11