Delta 36-650 Instruction Manual download pdf (Page 15)

7. Assemble the blade guard and splitter assembly (G)

Fig. 33, between the large washer (C) and the splitter

bracket and tighten screw (H) with wrench supplied.

8. Fasten the rear of the blade guard and splitter bracket

assembly (G) Fig. 34, to the rear splitter mounting

bracket. Align the hole in the blade guard and splitter

bracket with the hole in the rear splitter mounting

bracket. Insert a 5/16-18x5/8" carriage head screw

through the hole (J) in the blade guard and splitter

assembly and through the hole in the rear splitter

mounting bracket, place a 5/16" flat washer onto the

carriage head screw, thread a 5/16-18 hex nut onto the

carriage head screw and tighten securely. IMPORTANT:

The splitter (G) Fig. 34, has a notch (L) cut in the top

edge as shown. This feature will enable the blade guard

to stay in the raised position to make blade changing

easier. Raise the front of blade guard (M) Fig. 35, until

the rear edge of the blade guard slips into notch (L) of

splitter (G); the blade guard will stay in this position.

Fig. 33

Fig. 34

Fig. 35

Fig. 36

9. With the blade guard (L) Fig. 36, in the raised

position, assemble the saw blade (K) on the saw arbor

with two arbor wrenches supplied.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

No comments

Delta 36-650 Instruction Manual Page 15